For Christmas: order the Mini Drill Press by December 15 and tools by December 8. Free and trackedDrill press by Dec 15 for Christmas
0

Drill press and upgrades

The machine, the parts that bolt to it, and the spares that wear out. Start here if you are buying the press, or replacing something on one you already have.

17 products

  • Vise Clamp Plate 60 mm with Brass Hold-Downs

    Holds a small vise or a flanged fixture down on a 60 mm stage or base without drilling anything. Two brass hold-downs press on the vise's...

    $57.99 USD
    $57.99 USD
  • Spare 555 Motor 12/24 V, 3.17 mm Shaft
    Spare 555 Motor 12/24 V, 3.17 mm Shaft

    Spare 555 Motor 12/24 V, 3.17 mm Shaft

    A spare 555-size DC motor with a 3.17 mm shaft. The size that drives most small 12 V bench drills, including the head on our $129...

    $31.99 USD
    $31.99 USD
  • XYZ Micrometer Stage for Mini Drill Press, 40/60 mm

    XYZ Micrometer Stage for Mini Drill Press, 40/60 mm

    The XY stage moves the work side to side and front to back. This one adds a third micrometer that raises and lowers it. Three stages...

    $219.00 USD
    $219.00 USD
  • Micrometer head on its bracket with the cone pulley, screw and hex keysMikrabench lineup: chuck mini drill press with micro-feed kit, collet drill press, micrometer drill press and 120 x 150 mm base plate

    Micrometer Depth Stop Kit for Mini Drill Press — Mikrabench

    A drill press quill goes down as far as your hand pushes it. That is fine once. It is not fine forty times, when every hole...

    $59.99 USD
    $59.99 USD
  • XY micrometer stage, two micrometer headsXY micrometer stage, top plate with tapped holes
    XY micrometer stage, top plate with tapped holes

    XY Micrometer Stage for Mini Drill Press, 40/60 mm

    Line the hole up under the bit by turning a knob, not by nudging the part and hoping. This is a small two-axis stage of the...

    $125.00 USD
    $125.00 USD
  • The machine beside the micro bit caseThree Mikrabench mini drill presses side by side: chuck, collet and micrometer
    New

    Micrometer Drill Press, 3.175 mm Collet, 0.01 mm Depth — Mikrabench

    A micrometer head sits on top of the spindle. You turn it to set the depth, the thimble reads in hundredths, and the stroke is 10...

    $199.00 USD
    $199.00 USD
  • Aluminium base plate 120 by 150 mm with a split clamp collar for the columnThree Mikrabench drill presses and the 120 x 150 mm base plate with 13 mm column clamp

    Mini Drill Press Base Plate, 120 x 150 mm

    Open a mini drill press and look underneath. Four screws hold the rubber feet on, there is one unthreaded hole in the middle, and that is...

    $58.99 USD
    $58.99 USD
  • Rotary stage seen from aboveThe graduated rim and micrometer head

    Rotary Stage 60 mm, 360 Degree Micrometer Table

    An XY stage moves the work in a straight line. This one turns it, by a measured amount, and holds the angle while you work. 60...

    $69.00 USD
    $69.00 USD