-
Precision Parallel Set, 10 Pairs 1/8 x 4 inch, Hardened Steel Machinist Parallels in Case
Ten matched pairs of thin hardened steel parallels. Set a part on them in the vise and it sits flat, level and at exactly the height...
$59.00 USD$59.00 USD -
Outside Micrometer 0-1, 1-2 or 2-3 inch, 0.0001 inch, Carbide Tipped Machinist Micrometer
A machinist's outside micrometer that reads to one ten-thousandth of an inch. When a caliper is not close enough, this is the tool you reach for....
$39.00 USD$39.00 USD -
1-2-3 Blocks, Matched Pair, Hardened Steel with 11 Holes, 0.0001 inch
Two hardened steel blocks, exactly 1 x 2 x 3 inches, ground as a matched pair. Use them as a square, a height stop, a parallel...
$39.00 USD$39.00 USD -
Laser Tachometer, Non-Contact RPM Meter
Every spec sheet for a small drill press quotes an rpm. Almost nobody measures it. This does. Stick the small square of reflective tape on the...
$34.99 USD$34.99 USD -
Metal Stamping Set, 3 mm Letters or Numbers
A label falls off. Paint wears away. A struck character is still there in twenty years because it is not on the metal, it is in...
$94.99 USD$94.99 USD -
Carbide Scriber Engraving Pen, 10 Spare Tips
A pencil line on steel is 0.5 mm wide and rubs off when your hand crosses it. A scribed line is a groove. It is where...
$24.99 USD$24.99 USD -
Dial Indicator with Magnetic Base
The tool that tells you whether your machine is actually straight. Clamp the magnetic base, put the tip on the spindle, turn it by hand and...
$54.99 USD$54.99 USD -
Digital Caliper 6 inch / 150 mm, Fractions and mm
Most of the mistakes on a small bench are measuring mistakes. You drill 2 mm because the hole looked like 2 mm. A caliper ends that...
$39.00 USD$39.00 USD
