For Christmas: order the Mini Drill Press by December 15 and tools by December 8. Free and trackedDrill press by Dec 15 for Christmas
0

Vises and clamps

Holding the work still, which is most of the job. Vises that bolt to the drill press, bench vises that clamp to the desk edge, hand vises, brass watch and engraving vises, and a horned bench anvil for when the part needs a tap with a hammer.

18 products

  • 1 inch screwless toolmaker vise with Allen key1 inch screwless vise front view
    2 inch screwless toolmaker vise1 inch screwless vise front view
    3 inch screwless toolmaker vise1 inch screwless vise front view

    Screwless Toolmaker Vise 1, 2 or 3 inch, Precision Machinist Vise for Drill Press

    A ground steel block with a jaw that pulls down as it closes. The part sits flat and square, and the vise works lying down, on...

    $79.00 USD
    $79.00 USD
  • 2 inch precision grinding vise QGG50, hardened ground steelQGG50 toolmaker vise with knurled screw knob

    Precision Grinding Vise 2 or 2.5 inch QGG, Toolmaker Vise for Drill Press and Milling

    A solid block of hardened, ground steel that holds a part dead square. Set it on any of its sides and the part is still square....

    $99.00 USD
    $99.00 USD

  • Vise Clamp Plate 60 mm with Brass Hold-Downs

    Holds a small vise or a flanged fixture down on a 60 mm stage or base without drilling anything. Two brass hold-downs press on the vise's...

    $57.99 USD
    $57.99 USD
  • The ball vise on its rubber base with the full set of jaw pins and attachmentsBall vise tilted in the base to show the rotation

    Engraving Ball Vise, 3 or 5 inch, Jewelers Block

    You are setting a stone, or cutting a letter into a signet ring, and the part keeps shifting under the graver. A ball vise fixes that....

    $149.00 USD
    $149.00 USD
  • The 11 hole plate, sizes 0.2 to 1.2 mmSide view of the brass vise showing the knurled screw

    Brass Watch Vise with Graduated Staff Plate

    A watch staff is a fraction of a millimeter across. Hold it in an ordinary vise and you either crush it or it rolls out. This...

    $65.99 USD
    $65.99 USD
  • Horned bench anvil bolted to a wooden base, on a workbenchClose-up of the anvil horn with a brass wire being formed

    Horned Bench Anvil on Wooden Base, 128 mm

    A proper little horned anvil, bolted to a wooden block. It sits on the bench like it belongs there, and it earns its place the first...

    $79.99 USD
    $79.99 USD
  • Aluminium mounting plate 40 by 40 mm with a diamond cluster of tapped holesThe plate from above with its four fixing screws

    Vise Mounting Plate 40 x 40 mm, Aluminum

    A small vise and a sliding stage are made by different people who never spoke to each other. The vise has its own bolt pattern, the...

    $35.99 USD
    $35.99 USD
  • Mini bench vise on its round swivel base, jaws tiltedThe vise held in a hand, showing the ball joint and locking lever

    Mini Bench Vise, 1 inch Jaws, Swivel Base

    A vise bolted flat to the bench holds the work in one position. Then the job needs the piece tilted thirty degrees toward you, and you...

    $99.00 USD
    $99.00 USD